2010 chevy camaro coolant reservoir tank

#2010 chevy camaro coolant reservoir tank install#
#2010 chevy camaro coolant reservoir tank manual#
#2010 chevy camaro coolant reservoir tank full#
#2010 chevy camaro coolant reservoir tank pro#

For the bottom fill line, look closely at the inward facing side - maybe get a flashlight and it will be obvious. Just top off the bottom reservoir through the tiny fill cap next to the upper tank with 50/50 DEXCOOL mix and you'll be good to go.īoth the top and the bottom chambers have a cold fill line. And yeah, it's not uncommon for these cars to evaporate a bit of coolant off as it's used.

#2010 chevy camaro coolant reservoir tank full#

The top chamber should be completely full and you'll want to keep the bottom chamber roughly half full (can use the indentation on the rear side of the tank that the arrow is pointing at in the picture as a reference). I'm not aware of any cold fill line on the top chamber.

#2010 chevy camaro coolant reservoir tank manual#

Is this normal? I've read some places that the bottom chamber should be half full, but reading the manual multiple times it seems like maybe I don't worry about the lower chamber unless the top chamber isn't full? The instructions given to add coolant look like they are for either if the coolant is visible but not at or above the COLD FILL line, or if there is no coolant is visible in the coolant surge tank. The bottom chamber has very little in it, maybe 3/4', and I don't see any fill line. So with the engine cold, the top chamber is filled just about to the top, above the COLD FILL line. Made to keep your vehicles engine running cool Designed to maintain proper cooling level and prevent overheating. MotoRad recovery tank caps are designed and manufactured to offer precise control for the automotive cooling system. If coolant is visible but the coolant level is not at or above the COLD FILL line, add a 50/50 mixture of clean drinkable water and DEX-COOL coolant.' Chevy Camaro 2010, Engine Coolant Reservoir Cap by MotoRad®. A few things to note about coolant is that it is sweet tasting and highly toxic, so it can end up in the dogs stomach pretty quickly. This video shows you where the coolant reservoir, hoses and connections on your 2010 Camaro SS are located and the steps needed to fix minor leaks. According to the manual 'Check to see if coolant is visible in the coolant surge tank. Otherwise, your Camaro may have a radiator leak. Our six gallon tank hides the pump from top view as shown in the picture.Sorry to drag up an old thread, but want to make sure I understand this.

#2010 chevy camaro coolant reservoir tank pro#

Mishimoto Pro Cat-Back Quad Tip Exhaust, Mishimoto Catch Cans, Mishimoto Coolant Reservoir Tank, GM SEMA Grill, Ikon Motorsports OEM Front Fascia. Three, five and six gallons are available. Im kind of done bringing it back over and over again for a coolant flush and Chevy dealership could care less about. The one with the larger cap on top, the one with the dexcool labeled small cap under. the second pic is the three tanks I can see. The first picture shows two caps, one says dex-cool but is the size of a pencil and aft of the main reservoir cap that actually has coolant in it. Our options are a little different for the DC150 pump tanks because the pump is mounted on the side and that will take up roughly a gallon. Camaro 6th Gen V8 uses the Dexcool orange/pink coolant. The flow rate is a little better than the Rule 3700 at 14 volts with a good flowing system.Įach tank/pump will come with the correct feed port and fitting to use with the specified ordered pump. The DC150 pump is a better alternative to the Rule pumps because they have a better life span. Chevy Camaro 2010, Fuel Tank Anti-Squeak Insulator Set by OER®. Camaro 6th Gen V8 uses the Dexcool orange/pink coolant. PNR Chevy Camaro Gen 5 and ZL1 ice trunk tank to use with DC 150 pump. PNR intercooler reservoirs are designed and made in the USA. The 1″ and 16AN is usually for turbo and centrifugal supercharged, or modified intercoolers.) 50 feet of safety insulated heat hose that is made for this purpose, nylon clamps, insulated straps to hang hose, relay and inline fuse for all pumps, a brass ball valve and drain setup, stainless hardware for everything.

#2010 chevy camaro coolant reservoir tank install#

Each install kit will come with two choice of fittings of your choice, ( 12an and 3/4″ work with the factory and aftermarket superchargers.